Where do I set the zero point on my auto leveling system?
In there, near the top there is a set zero point selection. Once the RV is manually leveled the way I want it I go in there and set the zero point which is then used for subsequent auto leveling attempts. My Auto leveling system has been out of whack for a wile now. Curbside tires always end up off the ground. Has anyone recalibrated their system?
How does Ground Control 3.0 auto leveling work?
Thank you On Ground Control 3.0, you manually level the trailer front to back , side to side. Then, when all is leveled, turn off control panel and push 5 times up, and 5 times down arrows. You will see a screen come up stating Zero Point Configuration successful.
How do I Reset my Lippert auto leveling system?
Once you are satisfied with your leveling (I leveled my coach 1 degree high in the front so A/C condensation would drain at the rear of the coach) you turn off your leveling system and press front 5 times and then press rear 5 times your system should come on and indicate that calibration has been reset.
How does Ground Control 3.0 work for fifth wheel trailers?
This how-to video demonstrates just how easy it is to level your fifth-wheel trailer using Ground Control 3.0. Ground Control 3.0 by Lippert Components automatically levels your fifth-wheel trailer with just the push of a button. Level and stabilize your RV quickly and accurately and enhance your overall camping experience.
How does an automatic leveling system work on an RV?
Automatic leveling systems are supposed to automatically lower the jacks and level the RV with the push of a button. The system uses microprocessors to lower the appropriate jacks and raise the coach to a level condition.
How do you auto level a RV coach?
Press the Auto-Level button twice to begin the process and wait to see the results. The coach should relevel itself and all 4 LEDs should be out, both on the remote control panel, and on the printed circuit board. If the coach still is not level, check it again with your hand level.
Where is the Auto Level button on a coach?
On my coach it’s located right next to the batteries. If you can’t find yours, just press the auto-level button and track down where all the pump motor noise is coming from. The control circuitry is located behind a clear plexiglas panel that is held in place by a rubber grommet.
How does an RV ground control system work?
A push of a button is all it takes to this 5-point power leveling system to do its job. And for RV owners equipped with OneControl® technology and accessible WiFi, you can operate your Ground Control TT system, right from your phone.
